CPE & Access Gateway Products MP-202 Manuel d'utilisateur télécharger pdf (Page 11)

Application Note 4. SIP Logs

Version 2.6.1 11 June 2008

4.1 Configuration Examples

The following example configures the MP-20x for sending SIP logs (no filters – all logs are

open) to a Syslog server.

Assume the following:

 The host IP address is 10.16.2.4.

 The host port is 514.



To activate the SIP logs:

1. Run the following commands at the MP-20x terminal prompt:

rg_conf_set /voip/syslog/syslog_udp_terminal_flag 1

rg_conf_set /system/rv_log_filter 7

rg_conf_set /voip/syslog/syslog_server_addr 10.16.2.4

reconf 1

2. Activate the Wireshark application, and then reboot the MP-20x; the MP-20x sends

the SIP logs via Syslog server to the Host PC (see Figure 4-1).

Figure 4-1: Capturing the Syslog Packets in Wireshark

1 2 ... 6 7 8 9 10 11 12

Pas de commentaire

CPE & Access Gateway Products MP-202 Manuel d'utilisateur Page 11